![]() if carrier is out of safe area the device will send alarm to owner. ![]() I faced similar issue when trying to apply same pattern for notifications, but the "All devices" flag let me skip the equivalent of C step. Geo-fence will help you make safe area for your car/families. You can easily set reminders, upload receipts/documents, assign multiple users. Data what will be sent is only: Longtitude, latitude . This allows you to manage your fleet from anywhere, anytime, on any device. If I don't set "device readonly" on users, A won't be possible, but B and C are satisfied This would be for 1000 to 1500 gps device with interval of 1 minute. If I use the set "device readonly" on users, A and B are satisfied but C won't be possible. Downloaded the apk directly from and had the same result. I downloaded the Traccar client from android Play store, and android Malwarebytes informed me it has a problem 'Android/'. Then when it enters/exits geo-fence an event will be recorded and notification sent. Im looking into using Traccar and PHLocation2 for geofencing. Each device may be assigned one or multiple geo-fences. ![]() Specify the following : location of the guarded facility on the map geofence radius (from 150 m to 3000 m) Enable Geofence. Traccar is a free and open source modern GPS tracking system. Drag-and-drop hub location pin to specify the protected facility on the map. To enable geofence enter/exit notification for an admin or non-readonly user I have toġ- create geofence (settings > geofences)Ģ- associate geofence to my user or other user (settings > users > geofences)ģ- set device to send notification for that geofence (devices > select device > device settings > geofences)īut the general scenario is single admin user that creates users with lower permissions, then:Ī- users cannot add or remove devices (device readonly)Ĭ- users can select which geofence notifications receive for which devices There will be three types of geofences: line (with width in meters) circle (with radius in meters) polygon Geo-fences will be shown on a separate layer in map. I am trying to link a device with Geo fence using database directly on table tcdevicegeofence but after restarting the server the database is locking and not able to access the web anymore until I delete the added record and restart again.
0 Comments
Leave a Reply. |